Logo

P0711 Engine Trouble Code

Meaning of P0711 engine trouble code is a kind of powertrain trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $200-$300 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

P0711 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for P0711 code is occuring now you should check P0711 repair processes.
Now don't ask yourself; What should you do with P0711 code ?
The solution is here :

P0711 Possible Solution:

P0711 Engine

The crankshaft sensor signals the fuel injection computer or the ignition control when the cylinders are firing. This causes the ignition coil to provide a spark and the injector to inject fuel into each cylinder at the right time.If either sensor isn't working correctly, the car will run rough and the engine will be less efficient. In later car models, the car's computer can usually keep the vehicle running, but the engine warning light on the dashboard goes on to warn the driver.

P0711 Code Meaning :

P 0 7 1 1
OBD-II Diagnostic Powertrain (P) Trouble Code For Engine Intake Valve Control Solenoid Circuit Low Fuel Rail Pressure Sensor Circuit Malfunction Engine Shutoff Solenoid Malfunction Crankshaft Position Sensor A Circuit Low Input

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

P0711 OBD-II Diagnostic Powertrain (P) Trouble Code Description

P0711 OBD-II Trouble Code The Automatic Transmission (A/T) fluid temperature sensor detects the A/T fluid temperature and sends a signal to the Transmission Control Module (TCM). P0711 code.

Main reason For P0711 Code

The reason of P0711 OBD-II Engine Trouble Code is Fuel Rail Pressure Sensor Circuit Malfunction.

Parts or components should not be replaced with reference to only a P0711 DTC. The vehicle service manual should be consulted for more information on possible causes of the fault, along with required testing.